Love DAKboard and the fact that it uses RPI3 makes it great for projects especially with FLICKR being an add on photo source. With the help of great apps like Dakboard, she’s a prime candidate to move into the 21st century! She still transcribes it from the Alexa app on her laptop, rather than using her phone at the grocery store! Go figure! Oh, well, there’s still hope. I’ve got her using Alexa now for her shopping list, so all of us can add to it without wondering the paper list has gone. I almost have my wife convinced that this will be much better than the eraseboard on the refrigerator we’ve been using. I’m not sure which change did the trick, but I’m betting it was forcing the url early enough so it didn’t get messed up.Īnyway, it’s working great now, and the calendar in month mode seems to roll forward every week, not just a static month view. I put the url directly following the - kiosk command, and followed it with -incognito (with a single -, as suggested on another site). I think cut&paste from the instruction above introduces an extra line feed somehow. If you are having problems getting stuck at the “incognito” screen on startup, you might try entering the line in “autostart” directly rather than cut&paste. Get stuck? Buy the Wall Display or CPU in our shop. When you’re all done, plug it in, hang it on your wall and enjoy! There’s almost no bezel on the front, and the back cover pops off easily, leaving the frame which I then attached the photo frame wire to use for hanging! And third, the plastic case is perfect for this setup.This is crucial if you’re going to be mounting it to the wall, because if they face out, the monitor will stick out from the wall much further. Second, the HDMI and power connections on the back of the monitor face down, not straight out.First, it’s an IPS display, which means if you’re going to be hanging it vertically on the wall, you’ll still be able to see it when viewing at an angle greater than 90 degrees!.I used a Dell S S2340L 23-inch monitor for a few reasons: Install hardware on the back of the monitor Alternatively you can purchase a Pre-loaded DAKboard OS from the shop to load into your Raspberry Pi. Your Micro SD card should be 8GB or larger. We provide DAKboard OS for free to anyone, including instructions on how to install and configure. Check out our extensive collection of How-Tos and News in the Blog and our Support Site to personalize your screen. If you haven’t already done so, create an account (free!) and configure DAKboard. Micro USB or USB-C charger (for Raspberry Pi).8GB+ SD/Micro SD card – purchase a micro SD card in our shop.Raspberry Pi computer (version 3B+ or 4B recommended).Short HDMI cable (1 foot is perfect, but 3 feet works too).Monitor with HDMI input (preferably an IPS panel).Not into DIY? Check out the shop to purchase a Wall Display! Follow our instructions below to create a beautiful wall display for your photos, calendar, news and weather, powered by a Raspberry Pi!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |